基于DDC照明控制实验系统开发

论文编号:ZD1090    论文字数:20637,页数:62

摘  要
 随着经济的发展和科技的进步，智能楼宇不断涌现。各大高校也掀起了新校区建设的浪潮。相对于商业楼宇，照明在学校智能化建设中显得尤为重要。
 本设计主要是对智能照明系统进行研究，区别于以往使用的PLC，单片机等，本设计选择使用DDC（DDC模块型号为5201和5202）作为控制器，选择各种照明器件作为被控对象，进行研究。本设计首先完成传统的照明控制实验，然后进行DDC智能照明控制的设计，并与传统照明单一的手动控制的比较。本设计将DDC智能照明控制系统的设计主要分为DDC软件设计和现场组态软件的编程，进行了Lonworker软件和力控软件的开发。将硬件设计和以上两种软件的设计结合以后就能运用到实际的工程中，对于大型建筑的照明系统的监控非常方便。最后，本设计在开发后的基础上，还编写了适用于学生使用的实验指导书，以便进行试验台模拟实验。

关键词：智能照明；传统照明；绿色照明；DDC   

ABSTRACT
 With the economical development and scientific advance, the buildings equipped with intelligent facility emerge one after another. Building new schoolhouses has become a fever for most schools. Lightening is more important for the intelligent building of school than for commercial building.
 The design is mainly studied of the intelligent lighting system, different from the use of PLC and singlechip, this design is used for DDC (DDC models 5201 and 5202) as a controller, and choose a varity of lighting devices for the controlled object to studied. This design first complete traditional lighting control experiment, then design DDC intelligent lighting control system, and then compared with the traditional manual control of a single light. The design of the DDC intelligent lighting control system mainly divided into DDC software design and site configuration software programming, develop the Lonworker software and power-control software, if combination with hardware design and the above of two kinds of software design can be applied to practice project, it is very convenient for the large construction of lighting system to monitor. On the basis of the development of this design, also write for the Student USES experimental instructinto carry on the rig simulation experiment.
Keywords: intellectual lighting technology；Green lighing; traditional lighting; DDC

目 录
摘要……………………………………………………………………………….………..I
1 前言……………………………………………………………………………………..1
2 智能照明的现状及发展…………………………………………………………….2
2.1  智能照明的意义…………………………………………………………….…...2
2.2  智能照明的国内外发展现状………………………………………………........2
 2.2.1  国外智能照明的现状……………………………………………………...2
 2.2.2  国内智能照明的现状………………………………………………….......3
2.3  DDC智能照明设计的提出………………………………………………….…..4
3  总体方案设计………………………………………………………………………..6
 3.1  系统总体结构…………………………………………………………………...6
4  硬件电路设计……………………………………………………………...………..7
 4.1  灯具的选择…………………………………………………………………..….7
  4.1.1  常用的灯具…………………………………………………….…...........7
  4.1.2  常用的灯座…………………………………………………..…………...8
 4.2  开关的选择…………………………………………………….………….……..8
  4.2.1  常用开关…………………………………………………..………...........8
  4.2.2  智能感应开关……………………………………………….…….……...8
 4.3  照明控制原理…………………………………………………………………....9
 4.4  DDC介绍…………………………………………………………………..……10
5  DDC软件设计……………………………………………………......…………..…12
 5.1  Lonmaker介绍…………………………………………………………….…….12
 5.2  Lonmaker使用………………………………………………………………..…12
 5.2.1  LON总线简介…………………………………………………………..12
 5.2.2  Lonmaker总线接线图…………………………………………………..13
 5.2.3  Lonmaker开发...……….………………………………………………..14
 5.3  小结……………………………………………………………………………....23
6  现场组态软件编程…………………………………..…………………….………...24
 6.1  力控组态软件的简介…………………………………………………………....24
 6.2  力控组态软件的组成…………………………………………………………....25
 6.3  力控编程图………………………………………………………………………27
 6.4  力控组态软件的开发…………………………………………………...…….…27
 6.5  小结……………………………………………………………………...…….…29
7  总结…………………………………………………………………………………….30
致谢…………………………………………………………………………..….32
参考文献……………………………………………………………………..….33
附页…………………………………………………………………………..….34